Gargoyle block wireless to wired client how to#

Configure the options for the selected mode as required.In the tunneled mode, APs on the SSID route all traffic via the tunnel to a remote endpoint configured on the Tunnel Interface that you select. Tunneled mode is useful when you want to route network traffic on the SSID to and from a single end point, and apply policies at this end point. When you use NAT mode, the AP supplies clients with IP addresses from the built-in DHCP service on the access point and performs NAT for traffic between the wireless interface and the wired interface. With bridged mode, traffic is bridged between the wireless interface and the wired interface. WatchGuard APs can operate in Bridged mode, NAT (Network Address Translation) mode, or Tunneled mode.įor most use cases other than small remote sites we recommend you use bridged mode. Select the 11k Neighbour List and 11v BSS Transition check boxes.To configure 801.11k and 802.11v options: We recommend you enable both 802.11k and 802.11v, and with backwards compatibility mode enabled, so that devices that do not yet support these newer specifications can still join the wireless network. With 802.11v enabled, some RF information is exchanged, such as channel usage, but many other types of information are also shared, such as BSS transition management, Flexible Multicast Service (FMS), QoS traffic capability, and location services capabilities.

With 802.11k enabled, clients can make more informed roaming decisions with respect to the RF environment, such as channel load, link measurement, noise histogram, and neighbor reports. With 802.11k, APs and clients share RF environment information. Radio Resource Measurement (802.11k) and Wireless Network Management (802.11v) help measure, report and manage resources on a wireless network. The IEEE amendments 802.11k and 802.11v define enhanced information exchange that enables clients to make more informed roaming decisions.

The wireless network infrastructure can influence client roaming decisions with features such as load balancing, however, the final roaming decision is decided by client devices. Select the Over the DS and Mixed Mode settings as required.To configure 802.11r fast roaming settings We recommend you enable 802.11r with mixed-mode support so that SSIDs support both 802.11r and non-802.11r clients. The 802.11r standard significantly improves roaming times and can significantly improve streaming quality while roaming. WatchGuard APs support 802.11r fast roaming. Configure the Transmit Power for the radio, or select Automatic to automatically adjust power settings based on the RF environment.Expand the Radio Advanced Settings section.Select Configure >WiFi > Radio Settings.This is to compensate for better propagation of 2.4 GHZ signals as compared to 5 GHz. We recommend that you set AP transmit power levels for 2.4 GHz lower than those for 5 GHz. Smaller cells enable network designs to maximize channel reuse that can increase aggregate throughput and capacity for a wireless network. When you reduce AP transmit power, it helps to decrease the cell size. The recommended settings are based on the features available in WatchGuard Wi-Fi Cloud.

Gargoyle block wireless to wired client how to#

This section provides suggestions on how to deploy a wireless network that can support large high-density use cases.